Hi all.
I want to play my recently-purchased WARBL wind controller at my local
recorder music group, and I am using a RPi 3 with a HiFiBerryDAC+ sound
card with FluidSynth 2.1.6 compiled from source.
I am getting a "graininess" in the output at low volume. It sounds a bit
like a loose connection on the speaker (but it isn't that). What happens
is when a play a steady long note at CC2 of, say, 30 I hear step changes
in the volume. OK, I can't hold perfectly constant pressure, but I don't
hear the same things on other synths. It happens with different
soundfonts (so it's not the soundfont), and it happens with different
wind controllers (not just the WARBL). It doesn't happen at higher CC2s
above, say, 60.
I have tried putting a smoothing function into the incoming CC2s, and
that helps, but I don't like doing that.
Are there any settings that I should be adjusting?
Ben
_______________________________________________
fluid-dev mailing list
fluid-dev@nongnu.org
https://lists.nongnu.org/mailman/listinfo/fluid-dev
