It's happening again. This never happened when I was using Flex 3.5.
Make a change in the code. Do a Project | Clean. Make sure the
debugging session is over. Do a File |Refresh.
Start a debugging session and watch it go past a line:
if (adjInc < 0) // for
negatives
adjInc = 0;
Watch both lines (value at his point in this test is -43) execute.
After the assignment watch the value not change to zero, but stay at
-43.
Repeat above steps 2-3 times with no difference. Shut down Flash
Builder and start it again and repeat. No change.
I've only got a little hair left and don't think I can pull any more
out.
1) How can I force Flex to recognize code?
2) How can I force Flex (Flash Builder 4) to execute - as in making
an assignment - the code?
Jerry Davidson
