Hi Nyulos, Have you tried following the KB9012 flashing instructions at DangerousPrototypes wiki? http://dangerousprototypes.com/docs/Flashing_KB9012_with_Bus_Pirate Although that is for Bus Pirate / CH341A programmers and LA-A091P, should be similar for your Rayer programmer and LA-8241P motherboard. Most importantly, before plugging the power adapter you should unite three grounds: 1) GND of laptop's motherboard 2) GND of your programmer 3) GND of KB9012 Best regards, Mike Banon
On Tue, Jan 8, 2019 at 3:30 PM Nyúlós Lónyál <[email protected]> wrote: > > Hi! > > I'm trying to flash an ENE KB9012QF A3 KBC on LA-8241P motherboard. The > problem is flashrom can't detect the internal SPI of it, fails with error. > > flashrom p1.0-141-g9cecc7e on Linux 4.15.0-20-generic (x86_64) > flashrom is free software, get the source code at https://flashrom.org > > flashrom was built with libpci 3.5.2, GCC 7.3.0, little endian > Command line (5 args): ./flashrom -p rayer_spi -c KB9012 (EDI) -V > Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns). > Initializing rayer_spi programmer > Using address 0x378 as I/O base for parallel port access. > Using RayeR SPIPGM pinout. > The following protocols are supported: SPI. > Probing for ENE KB9012 (EDI), 128 kB: edi_chip_probe: reading hwversion failed > No EEPROM/flash device found. > Note: flashrom can never write if the flash chip isn't found automatically. > > How to get it working? Thanks a lot for help! > _______________________________________________ > flashrom mailing list -- [email protected] > To unsubscribe send an email to [email protected] _______________________________________________ flashrom mailing list -- [email protected] To unsubscribe send an email to [email protected]
