Hello, I've seen this issue in cases where the voltage is not set correctly.
What programmer are you using? A verbose log will also help. On Mon, Oct 15, 2018 at 11:28 PM MIAN VEREST <[email protected]> wrote: > Recently i start to use flashrom software, moreless in a winbond chip i > receive this message, is probably IC could be damage? > > Waiting for your comments. > > thanks in advance. > > Erasing and writing flash chip... Erase/write done in 8 min and 26 sec. > Verifying flash... FAILED at 0x00016650! Expected=0x3f, Found=0x3d, failed > byte count from 0x00000000-0x007fffff: 0x2 > Your flash chip is in an unknown state. > > > > > > _______________________________________________ > flashrom mailing list > [email protected] > https://mail.coreboot.org/mailman/listinfo/flashrom
_______________________________________________ flashrom mailing list [email protected] https://mail.coreboot.org/mailman/listinfo/flashrom
