From: Limin Wang <[email protected]>
Signed-off-by: Limin Wang <[email protected]>
---
doc/protocols.texi | 12 ++++++------
1 file changed, 6 insertions(+), 6 deletions(-)
diff --git a/doc/protocols.texi b/doc/protocols.texi
index e510019..7aa7585 100644
--- a/doc/protocols.texi
+++ b/doc/protocols.texi
@@ -1255,7 +1255,7 @@ options.
This protocol accepts the following options.
@table @option
-@item connect_timeout
+@item connect_timeout=@var{milliseconds}
Connection timeout; SRT cannot connect for RTT > 1500 msec
(2 handshake exchanges) with the default connect timeout of
3 seconds. This option applies to the caller and rendezvous
@@ -1286,7 +1286,7 @@ IP Type of Service. Applies to sender only. Default value
is 0xB8.
@item ipttl=@var{ttl}
IP Time To Live. Applies to sender only. Default value is 64.
-@item latency
+@item latency=@var{microseconds}
Timestamp-based Packet Delivery Delay.
Used to absorb bursts of missed packet retransmissions.
This flag sets both @option{rcvlatency} and @option{peerlatency}
@@ -1297,7 +1297,7 @@ when side is sender and @option{rcvlatency}
when side is receiver, and the bidirectional stream
sending is not supported.
-@item listen_timeout
+@item listen_timeout=@var{microseconds}
Set socket listen timeout.
@item maxbw=@var{bytes/seconds}
@@ -1377,7 +1377,7 @@ use a bigger maximum frame size, though not greater than
@item pkt_size=@var{bytes}
Alias for @samp{payload_size}.
-@item peerlatency
+@item peerlatency=@var{microseconds}
The latency value (as described in @option{rcvlatency}) that is
set by the sender side as a minimum value for the receiver.
@@ -1389,7 +1389,7 @@ Not required on receiver (set to 0),
key size obtained from sender in HaiCrypt handshake.
Default value is 0.
-@item rcvlatency
+@item rcvlatency=@var{microseconds}
The time that should elapse since the moment when the
packet was sent and the moment when it's delivered to
the receiver application in the receiving function.
@@ -1407,7 +1407,7 @@ Set UDP receive buffer size, expressed in bytes.
@item send_buffer_size=@var{bytes}
Set UDP send buffer size, expressed in bytes.
-@item timeout
+@item timeout=@var{microseconds}
Set raise error timeouts for read, write and connect operations. Note that the
SRT library has internal timeouts which can be controlled separately, the
value set here is only a cap on those.
--
2.9.5
_______________________________________________
ffmpeg-devel mailing list
[email protected]
https://ffmpeg.org/mailman/listinfo/ffmpeg-devel
To unsubscribe, visit link above, or email
[email protected] with subject "unsubscribe".
