Hi all, I managed to toast my shiny new Turbot. After update to latest UEFI firmware (X64.0094.R01) the board booted okay, but then I interrupted the booting linux by pressing the power reset button. (I had only serial console hooked up then, and only got the 'Grub loading' messages without any OS messages. So I wanted to hook up HDMI to get some output).
However, after the next reboot I just got garbage on the serial console, and the HDMI output remained blank (it didn't even get a synch signal). Both LED were on, though. Any ideas how I can resurrect the board? One of the improvements for the Turbot apparently is a 'NVRAM reset' jumper on J7 (?), but no documentation is to be had. So I'm not quite sure if it'll help me here. Any hints greatly appreciated. Cheers, Hannes -- Dr. Hannes Reinecke zSeries & Storage [email protected] +49 911 74053 688 SUSE LINUX Products GmbH, Maxfeldstr. 5, 90409 Nürnberg GF: J. Hawn, J. Guild, F. Imendörffer, HRB 16746 (AG Nürnberg) _______________________________________________ elinux-MinnowBoard mailing list [email protected] http://lists.elinux.org/mailman/listinfo/elinux-minnowboard
