Hi, I just finished installing the KSB2 module on my K2 QRP version (full optional). I go to operate for the first time but when I push the PTT I get this problem: the current absorbed increases (the voltage decrease) until it exceeds the value 4 A (set at this value after some test) and the K2 switch off. The current and the voltage values reading on the K2 display and on the multimeter are the same. I have this problem on all band but only in SSB mode (K2 works correctly on CW mode with full power 10-13W). The problem is repeated every time when I push the PTT. I use the microphone Heil MH-2. Any suggestions?
Good weekend Ciao, IZ1DUG, Fabio K2/QRP #1702 and K2/100 #5909 ------------------------------------------------------ Scegli infostrada: ADSL gratis per tutta lÂ’estate e telefoni senza canone Telecom http://click.libero.it/infostrada _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
