When soldering APP connectors, it is important to not get oversplash of
solder outside the cup, on the outer wall of the contact, or it does not
push into the shell to the locking point. Here, we tin the inside of the
cup, and the wire end, then insert the wire end and reheat the cup to join
them. If you use less solder than you think you need for each piece, it
turns out to be plenty.
-Stuart
K5KVH
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
