A few days ago I learned of a feature of the K2 I was unaware of.
Perhaps there's another one. Is it possible to configure the KAT2 so
that it is operational on ANT A, but switches straight through when
you select ANT B? I'm aware that I can tune up ANT B into a 50 ohm
load. The problem is that ANT B is a remotely tuned antenna, so it
won't always be 50 ohms, but the KAT2 needs to stay at it is while RF
is sent and the remote tuner does the tuning.
If the K2 can't do this, will the K3 be able to?
--
Julian, G4ILO
G4ILO's Shack: www.g4ilo.com
K2 s/n: 392 K3 s/n: ???
www.Ham-Directory.com: the best ham resources on the net
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
