Look, guys, code escrow is a valid discussion topic. I don't care if TenTec doesn't escrow their code, they should, and that's the point.
I agree when we go off into a discussion of open-source vs. proprietary trade secrets that it gets a little old (only because I have that discussion on other lists, too). But it's no worse than a lot of the other noise that populates this list from time to time. You have to take the good with the bad. I get tired of posts about whether the S-meter on the K2 is accurate, whether or not the Rework Eliminators are worthwhile, and how horrible it is to wind torroids but I know that there are people out there who care about all that stuff. 99% of what's posted here affects only 1% of the subscribers. But it's great when a subject comes up where you're one of the 1% for a couple days. So turn on vacation mode, or turn on digest mode, or just hit delete. About two more "when will this thread end" posts and there will have been more complaints about the thread than there were posts on the topic. :-) Craig NZ0R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Mark Bayern Sent: Sunday, June 10, 2007 5:34 PM To: John Reiser Cc: Elecraft; David Woolley Subject: Re: [Elecraft] K2: Firmware Escrow > Am I the only one who finds this entire topic cheeky and tiresome? Not sure about your definition of 'cheeky' -- but it is tiresome. If someone is that concerned about future software support, try getting a radio with out any software. Maybe they should just buy a Ten-Tec, or an I/Y/K. Those must come complete code for all the internal processors. <grin> I'm very happy with Elecraft's support. Mark AD5SS On 6/10/07, John Reiser <[EMAIL PROTECTED]> wrote: > Am I the only one who finds this entire topic cheeky and tiresome? > > John, W2GW > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
