Manuel, Strange LO BATT messages usually occur if the jumper on Control Board P7 is set to the EXT position. It should be set to the INT position for correct readings of the internal K2 voltage and current.
Those with older K2s may remember this well, there was a switch that was easily bumped into the wrong position instead of the jumper in the post SN 3000 K2s. If your switch IS in the correct position, check your power supply wire and its connections to see where the voltage is dropping significantly. 73, Don W3FPR > -----Original Message----- > Hello Elecrafters! > I have just finished building my new KAT100 and the XG2 . They both work > very well indeed. > > I am using a K2/100 (serial 5310) with a regular power supply off > 220 volts > and, occasionally, in the middle of my CW transmissions, the "Lo Batt" > message pops up on the display (beep included). The K2 carrys on keying. > > I thought this would only appear if you were using a battery of some kind > with low voltage delivery. Could this be an indication that my > power supply > is developing a problem? > > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.446 / Virus Database: 268.18.4/705 - Release Date: 2/27/2007 3:24 PM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
