I have been following the 135 ft flattop thread with interest. I was running my K1 into a 40m wire vertical via 100 ft of RG8x. After doing some loss calculations, that seemed pretty silly, so I set out for a more efficient. arrangement. I just put up a 40m folded dipole (same diameter wires) fed with 300 ohm window line. My K1 (with internal atu)tuned it well, but rf reeked havok on the K-40 keyer and such, so I used the BL2(4:1) balun and all seems well (probably time to do maintenance on the shack rf grounding system). My question is this: Is there a way to measure the insertion loss of the balun? Perhaps setting up my scope to do a differential measurement on the output of the balun w/ a 300ohm dummy load? Also, I could rig a way to sweep the antenna/window line with the antenna analyzer. Any suggestions? 72s, Pete wd4lst
Pete Axson WD4LST 17901 NE 18th Ave Citra, FL 32113 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
