I agree with Dave. The problem is very likely somewhere in your antenna
system, including the feedlines, matching stuff, etc. FWIW, I've been
using KAT500s with KPA500s since they were in beta, and we've used a
pair of them in W6GJB's contesting trailer for almost that long, and
we've never had the sort of issues you describe.
A LOT of antenna system problems like what you're describing are caused
by JUNK connectors. If it doesn't say Amphenol or is a MIL-surplus
connector stamped with a part number, it's junk. These no-name
connectors have all sorts of issues -- dissimilar metals, out of
tolerance dimensions, crummy dielectrics. I've been a ham since 1955,
but was off the air for long periods running my own small engineering
biz. When I got back on the air in 2003, I bought a bunch of adapters,
like inter-series, Tees, elbows, barrels. Over the next ten years, they
caused me a lot of problems that were tricky to find. Several were
exactly the sort of things you're describing.
A more fundamental question is, why are you not using resonant dipoles
in those trees? A 20-15-10 fan is easy to build and needs only 34 ft
horizontal. An 80-40 fan also loads on 15M. There's also a very nice
design using a pair of loading coils that resonates on two harmonically
related bands, like 80 and 40 or 40 and 20. The loading coils
approximately at what would be the end of the shorter dipole, with a
fairly short length of wire beyond the coils, so would fit in about 80
ft. If you decide you want to try one of those 2-band antennas, I'll
work up a design for you.
There's another very important reason for using resonant half-waves like
this -- receive noise. With an antenna that's matched to a coaxial
feedline, we can add a serious common mode choke at the feedpoint to
kill the noise that's picked up on the feedline and coupled to the
antenna and then to the receiver. Where most of us live, there's a lot
of noise that limits what we can work.
73, Jim K9YC
On 7/19/2025 11:52 AM, David Gilbert via Elecraft wrote:
You are making some very flawed assumptions here. The very fact that
both KAT500's are showing the exact same thing should have told you that
they are not the likely problem. Having "new coax" doesn't mean a thing
since there are several other possibilities ... connectors, the antenna
itself (including the ladder line or the connection to it), or even your
new coax. All of those could be fine at low power and yet be
problematic at higher power. In fact, if the problem showed up shortly
after you installed the new coax I'd bet $100 that the amps aren't the
source.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
