It's probably the AGC settings. Here are my favorites:
agc dcy soft
hld 0.2
pls nor
slp 000
thr cw20, rtty17, ssb15
f 200
s 020
I have pf2 programmed to bring up agc thr, so I can change it when
switching modes.
Dave Hachadorian, K6LL
Yuma, AZ
On 10/7/2024 6:24 AM, Chris wrote:
Hello,
I am a happy owner of K3. I came across another K3 with an early serial
number below 1000 in good condition at a local hamfest. It works well,
somehow better than my current K3, so my first reaction was, Wow. It seems
to have a lower noise floor and sounds slightly better.
My question is, how can it be? I have yet to compare all the settings for
either radio. The filter in my current K3 is 2.7kHz, and the new (new to
me) K3 has 2.8kHz. I am not 100% sure these filters can make that much
difference. Besides that, all hardware configurations are pretty much the
same. They both have updated KSYN3A modules. This K3 with a lower serial
number has KAT3, and my current K3 doesn't because I have KAT500.
Any suggestions?
Many thanks,
Chris KM1B
______________________________________________________________
Elecraft mailing list
Home:http://mailman.qth.net/mailman/listinfo/elecraft
Help:http://mailman.qth.net/mmfaq.htm
Post:mailto:[email protected]
This list hosted by:http://www.qsl.net
Please help support this email list:http://www.qsl.net/donate.html
Message delivered [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
