I use FLDIGI and in doing so I configure the radio PTT and KEY in the
FLDIGI application. When I load FLDIGI and go to CW mode, the radio
switches to CW mode and the PTT - KEY switches to RTS - DTR. When I
close FLDIGI the radio switches back to OFF - OFF. I've checked another
couple of applications that I rarely use and they control the radio
correctly. So I'd say the configuration is handled by and saved the
application and NOT the radio.
One MUST always shut the K3S down by the power switch on the front
panel, and never by the power supply.
73
Bob, K4TAX
On 7/4/2024 2:36 PM, [email protected] wrote:
Message: 18
Date: Thu, 4 Jul 2024 12:23:00 -0400
From: Frank Stein<[email protected]>
To:[email protected]
Cc:[email protected]
Subject: Re: [Elecraft] PTT-Key Settings won't save
Message-ID:
<cad97bpqojzv7skdvxxkkjzv3szg0t+epcjega87dbhrayza...@mail.gmail.com>
Content-Type: text/plain; charset="UTF-8"
Just clarify this strange behavior.
I use the Config Menu to set the PTT-Key to RTS-DTR. As long as I don't
turn off the rig, it works correctly. Once I turn off via the front panel
power switch, it loses this setting and goes back to OFF-OFF.
If while it is set to RTS-DTR I do a SAVE CONFIGURATION in the utility, I
can restore to the RTS-DTR values until I turn my power off.
Then it goes back to OFF-OFF.
Other config settings such a 1 or 2 speakers still can be changed and the
change is stored even after a power off/on.
Where are the settings stored in the K3? EPROM? Could one memory cell in
an EPROM go bad?
Is there a way to "factory reset" or something to clear this problem?
Thanks,
Frank
W4TG
--
I want to go to Bora-Bora, but I’m too Pora-Pora.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
