On Monday 16 January 2006 03:35, Clint Sprague wrote: > When you install a component on the printed > side of the circuit board, and then you tip the board > over to solder, what are accepted methods to keep the > compenent from falling off?
I use a pencil eraser between the board and workbench to hold the part in place. I don't like the look of solder pads where the component leads have been bent. Ian, G4ICV, AB2GR, K2 #4962 -- _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
