On 31/10/2025 10:05, Iker Pedrosa wrote:
> +
> +static void st7920_hw_reset(struct st7920_device *st7920)
> +{
> + if (!st7920->reset_gpio)
> + return;
> +
> + gpiod_set_value_cansleep(st7920->reset_gpio, 0);
> + usleep_range(15, 20);
> + gpiod_set_value_cansleep(st7920->reset_gpio, 1);
This is odd. Why are you keeping device in reset state?
I don't think you tested your driver with DTS.
> + msleep(40);
> +}
> +
> +
> + regmap = devm_regmap_init_spi(spi, &st7920_spi_regmap_config);
> + if (IS_ERR(regmap))
> + return PTR_ERR(regmap);
> +
> + st7920 = devm_drm_dev_alloc(dev, &st7920_drm_driver,
> + struct st7920_device, drm);
> + if (IS_ERR(st7920))
> + return PTR_ERR(st7920);
> +
> + drm = &st7920->drm;
> +
> + st7920->dev = dev;
> + st7920->regmap = regmap;
> + st7920->spi = spi;
> + st7920->device_info = device_get_match_data(dev);
> + st7920->width = st7920->device_info->default_width;
> + st7920->height = st7920->device_info->default_height;
> +
> + st7920->reset_gpio = devm_gpiod_get_optional(dev, "reset",
> GPIOD_OUT_HIGH);
So you keep device in reset state, then why do you toggle it in
st7920_hw_reset()? Remember that this is the logical, not line level.
> + if (IS_ERR(st7920->reset_gpio)) {
> + ret = PTR_ERR(st7920->reset_gpio);
> + dev_err(dev, "Unable to retrieve reset GPIO: %d\n", ret);
return dev_err_probe, didn't you get comment on that?
> + return ret;
> + }
> +
> + spi_set_drvdata(spi, st7920);
> +
> + ret = st7920_init_modeset(st7920);
> + if (ret)
> + return ret;
> +
> + ret = drm_dev_register(drm, 0);
> + if (ret)
> + return dev_err_probe(dev, ret, "DRM device register failed\n");
> +
> + drm_client_setup(drm, NULL);
> +
Best regards,
Krzysztof
