On 2023-06-24 11:08:30, Krzysztof Kozlowski wrote:
> On 24/06/2023 02:41, Marijn Suijten wrote:
> > The downsteam driver for dispcc only ever gets and puts this clock
> > without ever using it in the clocktree; this unnecessary workaround was
> > never ported to mainline, hence the driver doesn't consume this clock
> > and shouldn't be required by the bindings.
> >
> > Fixes: 8397c9c0c26b ("dt-bindings: clock: add QCOM SM6125 display clock
> > bindings")
> > Signed-off-by: Marijn Suijten <[email protected]>
> > ---
>
> In perfect would we would like to know whether hardware needs this clock
> enabled/controlled, not whether some driver needs it. I understand
> though that with lack of proper docs we rely on drivers, so:
It might only use this to figure out if those clocks have already probed
or are available. The logic goes as follows:
clk = devm_clk_get(&pdev->dev, "cfg_ahb_clk");
if (IS_ERR(clk)) {
if (PTR_ERR(clk) != -EPROBE_DEFER)
dev_err(&pdev->dev, "Unable to get ahb clock handle\n");
return PTR_ERR(clk);
}
devm_clk_put(&pdev->dev, clk);
Nothing else uses/parents cfg_ahb_clk. Maybe with clk_ignore_unused or
similar, it gets turned on but never off again?
Indeed, a lack of documentation and comment from the manufacturer makes
it impossible to know, and ignoring it (as the driver already does)
works just fine.
> Reviewed-by: Krzysztof Kozlowski <[email protected]>
Thanks!
- Marijn
>
> Best regards,
> Krzysztof
>
