On 11/6/20 12:21 pm, Chris Johns wrote: > On 1/6/20 12:22 am, Jan Sommer wrote: >> Hello, >> >> Here is a patch set which should enable SMP again for the pc386-based BSPs >> (mainly tested with pc686). > > Many thanks for these patches and your efforts. > >> So far I only tested it with qemu. Tests on real hardware are pending. > > It would be good to test results for hardware with SMP disabled. If the test > results do not show any regressions then I am fine with these patches for > RTEMS > 5.2 with SMP documented as experimental. I will take a look at doing this.
I have finally managed to get my test PC to load a iPXE loader and with that I can boot RTEMS. Without the changes I can run hello.exe and it prints the right stuff on the monitor however the iPXE boot command line that use to work ... chain tftp://10.10.5.2/rtems.exe --console=/dev/com1,115200 --printk=/dev/com1,115200 ... does not generate any serial output. The output is being redirected and the serial port because nothing appears on the monitor and I tested the cable is working with a loop-back jumper. Is the PC serial port driver broken? Chris _______________________________________________ devel mailing list devel@rtems.org http://lists.rtems.org/mailman/listinfo/devel
