Hello, I was trying to build rtems for lm3s6965 bsp when i made a mistake on the name of the bsp at --enable-rtemsbsp flag. Suprisely i did not get an error Of course i did't get the well known 'make all' will build the following BSPslm3s6965 either. Even later when i did make, no error message popped up. Is there a reason for not stopping the configure script and alert the user about the error? In other words, should rtems configure script notice the user made a mistake and prompt an error message?
-- Aurelio Remonda Software Engineer San Lorenzo 47, 3rd Floor, Office 5 Córdoba, Argentina Phone: +54-351-4217888 / 4218211 _______________________________________________ devel mailing list devel@rtems.org http://lists.rtems.org/mailman/listinfo/devel
