On 2014-07-18 09:39, Giovanni Macciocu wrote:
Hi Emanuel,
RTEMS has a BSP which is named xilinx_zynq_zedboard, I use the following
configuration to build RTEMS for this BSP.
$ ../configure --target=arm-rtems4.11 --enable-rtemsbsp=xilinx_zynq_zedboard
--prefix=/opt/rtems-4.11 --enable-posix --enable-networking
Hello Giovanni,
Yes, I noticed that. But I was hoping for a little write up, or how-to,
on how to use it, or how is it intended to be used.
We still use the U-Boot to load it?
Cheers & thanks
_______________________________________________
devel mailing list
devel@rtems.org
http://lists.rtems.org/mailman/listinfo/devel
