Hi Bob, Im using the following I'm using http://git.kernel.org/cgit/linux/kernel/git/jberg/mac80211-next.git/ build with Bob Copland's patches from http://bobcopeland.com/kernel/wl/20150812/ I also set ath10k with rawmode=1 on module load. Patch from https://patchwork.kernel.org/patch/6600721/
iw Version 4.1.3 Authsae latest git version Radios are Doodlelabs ACM-DB-3 Ath10k firmware https://github.com/kvalo/ath10k-firmware/blob/master/10.2.4/untested/firmware-5.bin_10.2.4.70.2 Note: If I replace the Radios with Compex WLE900VX-7A I cannot get a unencrypted link over 100Mbps Fred On Wed, Aug 26, 2015 at 12:14 PM, Bob Copeland <[email protected]> wrote: > On Wed, Aug 26, 2015 at 09:39:31AM -0400, fred veldini via Devel wrote: > > Hello, > > > > Is there a way to setup Authsae with VHT support? > > I was playing around with ath10k and have a mesh setup with 80MHz > > getting 310-340Mbps. I wanted to test Authsae but it changes the 80MHz > down > > to 40MHz > > Right now, no -- authsae doesn't include VHT IEs at least, nor send the > right stuff to the kernel when peers are created. > > > I tried wpa_supplicant with SAE support but it constantly says LISTEN and > > BLOCKED > > with iw dev mesh0 station dump. > > I haven't tested either, myself. There's a little work to do there. > > Which patchset are you using for unencrypted mesh? I am not seeing > aggregation working with my rawmode patchset (I did at one point > record 100+ mbps so it *did* work at some point -- I think with normal > decap plus raw TX, but in that case multihop was not working.) > > -- > Bob Copeland %% http://bobcopeland.com/ >
_______________________________________________ Devel mailing list [email protected] http://lists.open80211s.org/cgi-bin/mailman/listinfo/devel
