---------- Forwarded message --------- 发件人： 孟非 <[email protected]> Date: 2023年4月21日周五 10:30 Subject: Fwd: 【Discuss】About the flow rate control function To: <[email protected]>
请高老师转发给[email protected] 邮件。 ---------- Forwarded message --------- 发件人： 孟非 <[email protected]> Date: 2023年4月20日周四 17:38 Subject: 【Discuss】About the flow rate control function To: <[email protected]> Dear all， About the flow rate control function, do you think the flow rate control should be set for the job level? Or do you set flow rate control for each pipeline under job? For example, if a job has multiple pipelines, each pipeline has the same flow rate (for example, limiting the average synchronization of N lines per second) after flow rate control is set for the job. If the flow rate is at the pipeline level, different flow rates can be set. If you have other ideas, feel free to contribute to the discussion! Which of the following locations would you prefer to have speed limit controls? A. job (Task level. After the job level is set, rate limits are set for all data pipes. This task may have to deal with 1 or more data pipes) B. source (Note: Set only at the source end of the data pipe. After the setting is successful, set the speed limit for the data pipe where it is located.) C. sink (Note: only set at the target end of the data pipe. After the setting is successful, the speed limit of the data pipe is set according to this value) D. source and sink (Note: both sides can be set, and the speed limit of the data pipe where they are located is set according to this. If the rate is different, the speed limit is set according to the minimum value) E. Your other suggestions Yours sincerely， Monica -- Best Regards ------------ EricJoy2048 [email protected]
