From: Sandeep Penigalapati <[email protected]>

Shared UMEM is meant to be shared by a limited number of sockets,
governed by the mempool size (max_xsks). When the UMEM was already at
capacity (refcnt >= max_xsks), xdp_umem_configure() returned the UMEM
without incrementing its refcount, so the extra socket used it
unaccounted for.

This missing reference has two consequences. During queue setup the
fill-queue reservation is chosen from the refcount, so the sharing
socket reserves into its own uninitialised fill queue and crashes. At
close, the under-counted refcount reaches zero while the UMEM is still
in use, freeing it early and causing a use-after-free.

Reject sharing once the UMEM is at capacity by returning NULL, so queue
setup fails cleanly with -ENOMEM. This applies the per-mempool socket
limit that shared UMEM was always intended to respect.

Harden the failure path this makes reachable: clear rxq->umem and its
paired txq->umem when xsk_configure() fails, and skip queues whose UMEM
is not yet set in get_shared_umem(), so a later scan over the same
mempool cannot dereference a NULL or dangling UMEM.

Also document the shared mempool sizing requirement (4096 mbufs per
socket).

Note: on stable branches this is a behaviour change. Shared-UMEM setups
that previously appeared to start, until the fill-queue crash or the
use-after-free at close, now fail cleanly at Rx queue setup with
-ENOMEM.

Fixes: 74b46340e2d4 ("net/af_xdp: support shared UMEM")
Cc: [email protected]

Signed-off-by: Sandeep Penigalapati <[email protected]>
---
v3:
- Move the NULL umem check after ctx_exists() so a failed queue is still
  checked for a duplicate context, as before.
- Shorten the "at capacity" log to one line and drop the count (always
  the max here).
- Also clear txq->umem, not just rxq->umem, when setup fails.
- Clarify "AF_XDP socket" in the doc.

 doc/guides/nics/af_xdp.rst          |  7 +++++++
 drivers/net/af_xdp/rte_eth_af_xdp.c | 19 ++++++++++++++++---
 2 files changed, 23 insertions(+), 3 deletions(-)

diff --git a/doc/guides/nics/af_xdp.rst b/doc/guides/nics/af_xdp.rst
index c455b4c066..cf4eeb63d0 100644
--- a/doc/guides/nics/af_xdp.rst
+++ b/doc/guides/nics/af_xdp.rst
@@ -99,6 +99,13 @@ configured like so:
     --vdev net_af_xdp0,iface=ens786f1,shared_umem=1 \
     --vdev net_af_xdp1,iface=ens786f2,shared_umem=1
 
+The shared mempool must be large enough for every AF_XDP socket sharing
+the UMEM.
+Each socket requires 4096 mbufs, so a UMEM shared by ``N`` sockets needs at
+least ``4096 * N`` mbufs.
+Rx queue setup fails if the mempool is too small to add another socket to the
+UMEM.
+
 xdp_prog
 ~~~~~~~~
 
diff --git a/drivers/net/af_xdp/rte_eth_af_xdp.c 
b/drivers/net/af_xdp/rte_eth_af_xdp.c
index 2cdb533276..3838d52d5d 100644
--- a/drivers/net/af_xdp/rte_eth_af_xdp.c
+++ b/drivers/net/af_xdp/rte_eth_af_xdp.c
@@ -1154,6 +1154,9 @@ get_shared_umem(struct pkt_rx_queue *rxq, const char 
*ifname,
                                        ret = -1;
                                        goto out;
                                }
+                               /* A failed setup leaves mb_pool set with no 
umem. */
+                               if (internals->rx_queues[i].umem == NULL)
+                                       continue;
                                if 
(rte_atomic_load_explicit(&internals->rx_queues[i].umem->refcnt,
                                                    rte_memory_order_acquire)) {
                                        *umem = internals->rx_queues[i].umem;
@@ -1188,9 +1191,16 @@ xsk_umem_info *xdp_umem_configure(struct pmd_internals 
*internals,
                if (get_shared_umem(rxq, internals->if_name, &umem) < 0)
                        return NULL;
 
-               if (umem != NULL &&
-                       rte_atomic_load_explicit(&umem->refcnt, 
rte_memory_order_acquire) <
-                                       umem->max_xsks) {
+               if (umem != NULL) {
+                       /* Reject sharing once the UMEM is at capacity. */
+                       if (rte_atomic_load_explicit(&umem->refcnt,
+                                       rte_memory_order_acquire) >= 
umem->max_xsks) {
+                               AF_XDP_LOG_LINE(ERR, "%s,qid%i: UMEM %s already 
at max %u sockets",
+                                               internals->if_name, 
rxq->xsk_queue_idx,
+                                               umem->mb_pool->name, 
umem->max_xsks);
+                               return NULL;
+                       }
+
                        AF_XDP_LOG_LINE(INFO, "%s,qid%i sharing UMEM",
                                        internals->if_name, rxq->xsk_queue_idx);
                        rte_atomic_fetch_add_explicit(&umem->refcnt, 1, 
rte_memory_order_acquire);
@@ -1818,6 +1828,9 @@ xsk_configure(struct pmd_internals *internals, struct 
pkt_rx_queue *rxq,
 out_umem:
        if (rte_atomic_fetch_sub_explicit(&rxq->umem->refcnt, 1, 
rte_memory_order_acquire) - 1 == 0)
                xdp_umem_destroy(rxq->umem);
+       /* Drop dangling pointers so a later shared-UMEM scan skips this queue. 
*/
+       rxq->umem = NULL;
+       txq->umem = NULL;
 
        return ret;
 }
-- 
2.27.0

Reply via email to