On Fri, 19 Mar 2004 20:53:54 -0600 Nathan Malmberg <[EMAIL PROTECTED]> wrote:
> On Fri, Mar 19, 2004 at 09:59:30AM -0800, Rodney D. Myers wrote:
> > All of the correct modules are being loaded, but when I attempt to
> > run"/etc/init.d/pcmcia start', the process just hangs, sitting at
> > this message;
> >
> > Starting PCMCIA Services: Intel PCIC probe: Not Found
> > using yenta_socket instead of i82365
> > cs: cb_alloc (bus 3):vendor 0x115d, device 0x0003
> > PCI: Enabling device 03:00.0 (0000 -> 0x0003)
> > eth0: Xircom CardBus revision 3 at irq 10
> > PCI: Enabling device 03:00.1 (0000 -> 0003)
> > ttyS04 at port 0x4080 (irq = 10 ) is a 16550A
> > cardmgr[408]: watching 2 sockets
> > cs: IO probe 0x0c00-0x0cff: clean
> > cs: IO probe 0x0800-0x08ff:
>
> Remove the 0x800-0x8ff port range from the included ports in
> /etc/pcmcia/config.opts.
>
> Nate
>
Thanks. I have this printed out, and I'll try this weekend.
--
Rodney D. Myers <[EMAIL PROTECTED]> Registered Linux User #96112
ICQ#: AIM#: YAHOO:
18002350 mailman452 mailman42_5
They that can give up essential liberty to obtain a
little temporary safety deserve neither liberty nor safety.
Ben Franklin - 1759
pgp00000.pgp
Description: PGP signature
