I think all the following should support both your cards (don't how the pci support is).
On Wed, Feb 11, 2004 at 11:13:59PM -0500, Tom Vier wrote: > > If its ati then its supported by both the proprietry ati modules and > > the dri cvs version (there are debian packages, I can try to look them > > up for you if you want). > > xfree86.org says it isn't supported. i found a site that says you can use > ChipID in the conf to force it, but that didn't work either. > Try here for the ati proprietary drivers: http://www.ati.com/support/drivers/linux/radeon-linux.html?type=linux&prodType=graphic&prod=productsLINUXdriver&submit.x=7&submit.y=9&submit=GO%21 There are versions for X 4.(123) There is a note about installing it for debian in the documentation but it basically says you need to use alian and force the installation. You can also look at http://xoomer.virgilio.it/flavio.stanchina/debian/fglrx-installer.html for a more complete method of building debian packages from the ati version including some prebuilt packages (haven't checked the versions). > i didn't find any cvs on packages.debian.org for xfree86. i'd appreciate it > if you can point me to some debs that support the 9200. > For the open dri cvs version of the packages look at: http://people.debian.org/~daenzer/dri-trunk-unstable/ I think the sources.list line should be deb http://people.debian.org/~daenzer/dri-trunk-unstable/ ./ I think those are only for X 4.3 > > Could it be an interrupt clash? What happens if you move it to a > > different pci slot? (sometimes helps when using two network cards). > > it turns out this was the problem (it should be uncommented): > > > > #Section "DRI" > > > # Mode 0666 > > > #EndSection > > -- > Tom Vier <[EMAIL PROTECTED]> > DSA Key ID 0xE6CB97DA > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > > > +++++++++++++++++++++++++++++++++++++++++++ > This Mail Was Scanned By Mail-seCure System > at the Tel-Aviv University CC. > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
