On Wed, 11 Feb 2004 14:49:48 +0200, Micha Feigin <[EMAIL PROTECTED]> wrote in message <[EMAIL PROTECTED]>:
> On Wed, Feb 11, 2004 at 09:30:00AM +0100, David Baron wrote: > > <<<<<<< > > Make sure you have the following line in the module section > > Load "dri" > > > > Also add the following section if it doesn't exist > > Section "DRI" > > Mode 0666 > > EndSection > > <<<<<<<< > > > > These have been there. The rest of the files, XF86Config and -4 look > > to be in order. Most GL apps still do not come up. The Quake window > > comes up but does not paint its contents, hangs. > > > > Do I need the call any of the new modules in /etc/modules. Is there > > anything else that needs to be touched to make this stuff work? > > > > Make sure the mach64 and the agpgart kernel module are loaded and > check that the use count at least on the mach64 goes up to 1 when X is > started. > > Try running glxinfo and see near the top if it reports that dri is > enabled. > > Look in /var/log/XFree86.0.log to see if there are any error messages > related to drm/dri. Also look to see that the mach64 is recognized > properly (or mail the file if you don't understand the errors). ..post the file, there are more of us mach64 people here, I've got 2 and can use this thread as an howto reference. ;-) -- ..med vennlig hilsen = with Kind Regards from Arnt... ;-) ...with a number of polar bear hunters in his ancestry... Scenarios always come in sets of three: best case, worst case, and just in case. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
