On Tue, Dec 30, 2003 at 10:08:12AM -0600, Hugo Vanwoerkom wrote: > Akira Kitada wrote: > >Hi all. > > > > a few days ago, I had 82.3GB disk installed on my box > >as primary slave. > >after that, I turned it on and reading messages of kernel, > >and found messages that means 'hdb' recognized smoothly. > >that's good. > >badly, I found some error messages too, > >and noticed booting is very slower than before. > >the messages is below. > > You did not specify what kernel but I had to include a kernel > module to get proper DMA working.
I'm using Linux 2.4.22 as I wrote the first mail ;-) well, you seem to suspect that it's a problem of lack of proper module, don't you? if so, why doesn't it happen till I put hdd on? I can't stop wondering why? > Check ATA/IDE/MFM/RLL support -> IDE,ATA and ATAPI Block Devices -> > > In my case I checked VIA82CXXX. Check out which module pertains to > your disk. I am using 2.4.23 mine is below. VIA82CXXX is out, seem to be involving as you say. # egrep 'VIA' config-2.4.22 # CONFIG_MVIAC3_2 is not set # CONFIG_BLK_DEV_VIA82CXXX is not set # CONFIG_VIA_RHINE is not set # CONFIG_VIA_RHINE_MMIO is not set CONFIG_AGP_VIA=y # CONFIG_SOUND_VIA82CXXX is not set # CONFIG_MIDI_VIA82CXXX is not set > > Congratulations with the new HDD ;-) Thanks! I use it little because of this trouble, though ;( -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]