didier gaumet wrote: > I would think that pwmconfig complains that it finds 3-pins > fans set up to PWM mode (4-pins required) > > Your UEFI propose either to setup your fans globally or > individually and I think that by default the setup is > global. This would probably be fine il all your fans were > either 3-pins (DC mode) or 4-pins (preferably PWM mode but > DC mode is possibility). But you have both installed. > A solution could be, in your UEFI, to individually set up > all your 4-pins fans to PWM mode, while setting up all your > 3-pins fans to DC mode.
Yeah, or replace the 3-pins with 4-pins? re: pwmconfig, here is what it says: $ sudo pwmconfig # pwmconfig version 3.6.0 This program will search your sensors for pulse width modulation (pwm) controls, and test each one to see if it controls a fan on your motherboard. Note that many motherboards do not have pwm circuitry installed, even if your sensor chip supports pwm. We will attempt to briefly stop each fan using the pwm controls. The program will attempt to restore each fan to full speed after testing. However, it is ** very important ** that you physically verify that the fans have been to full speed after the program has completed. Found the following devices: hwmon0 is k10temp hwmon1 is asus hwmon2 is nouveau Found the following PWM controls: hwmon2/pwm1 current value: 52 hwmon2/pwm1 is currently setup for automatic speed control. In general, automatic mode is preferred over manual mode, as it is more efficient and it reacts faster. Are you sure that you want to setup this output for manual control? (n) y Giving the fans some time to reach full speed... Found the following fan sensors: hwmon1/fan1_input current speed: 0 ... skipping! There are no working fan sensors, all readings are 0. Make sure you have a 3-wire fan connected. You may also need to increase the fan divisors. See doc/fan-divisors for more information. -- underground experts united https://dataswamp.org/~incal
