Hello, I have two identical HP servers running Debian 9. One of them is a clean install of 9, whereas the other was upgraded from Debian 8.
The one that was upgraded has no networking issues (indeed, it still uses the ethX interface names). However, the one that was installed from scratch is having an issue which I can't seem to figure out. There are 4 network interfaces -- eno[1-4] -- but they are all getting mapped to eth0. It looks like they were mapped correctly until I reloaded the network driver a few days ago. Any idea how I can get them back into a 1:1 mapping with the actual physical interfaces, instead of all pointing to the same one? Some dmesg output for reference: [Wed Mar 28 17:00:45 2018] tg3.c:v3.137 (May 11, 2014) [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.0 eth0: Tigon3 [partno(629133-001) rev 5719001] (PCI Express) MAC address d8:9d:67:2c:ec:e0 [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.0 eth0: attached PHY is 5719C (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[1]) [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.0 eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1] [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.0 eth0: dma_rwctrl[00000001] dma_mask[64-bit] [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.1 eth1: Tigon3 [partno(629133-001) rev 5719001] (PCI Express) MAC address d8:9d:67:2c:ec:e1 [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.1 eth1: attached PHY is 5719C (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[1]) [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.1 eth1: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1] [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.1 eth1: dma_rwctrl[00000001] dma_mask[64-bit] [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.2 eth2: Tigon3 [partno(629133-001) rev 5719001] (PCI Express) MAC address d8:9d:67:2c:ec:e2 [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.2 eth2: attached PHY is 5719C (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[1]) [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.2 eth2: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1] [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.2 eth2: dma_rwctrl[00000001] dma_mask[64-bit] [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.3 eth3: Tigon3 [partno(629133-001) rev 5719001] (PCI Express) MAC address d8:9d:67:2c:ec:e3 [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.3 eth3: attached PHY is 5719C (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[1]) [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.3 eth3: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1] [Wed Mar 28 17:00:45 2018] tg3 0000:03:00.3 eth3: dma_rwctrl[00000001] dma_mask[64-bit] *[Wed Mar 28 17:00:45 2018] tg3 0000:03:00.1 eno2: renamed from eth1[Wed Mar 28 17:00:45 2018] tg3 0000:03:00.0 eno1: renamed from eth0[Wed Mar 28 17:00:45 2018] tg3 0000:03:00.3 eno4: renamed from eth3[Wed Mar 28 17:00:45 2018] tg3 0000:03:00.2 eno3: renamed from eth2* Looks fine, but then... [Wed Mar 28 17:12:33 2018] tg3.c:v3.137 (May 11, 2014) [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.0 eth0: Tigon3 [partno(629133-001) rev 5719001] (PCI Express) MAC address d8:9d:67:2c:ec:e0 [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.0 eth0: attached PHY is 5719C (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[1]) [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.0 eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1] [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.0 eth0: dma_rwctrl[00000001] dma_mask[64-bit] *[Wed Mar 28 17:12:33 2018] tg3 0000:03:00.0 eno1: renamed from eth0* [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.1 eth0: Tigon3 [partno(629133-001) rev 5719001] (PCI Express) MAC address d8:9d:67:2c:ec:e1 [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.1 eth0: attached PHY is 5719C (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[1]) [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.1 eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1] [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.1 eth0: dma_rwctrl[00000001] dma_mask[64-bit] *[Wed Mar 28 17:12:33 2018] tg3 0000:03:00.1 eno2: renamed from eth0* [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.2 eth0: Tigon3 [partno(629133-001) rev 5719001] (PCI Express) MAC address d8:9d:67:2c:ec:e2 [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.2 eth0: attached PHY is 5719C (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[1]) [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.2 eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1] [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.2 eth0: dma_rwctrl[00000001] dma_mask[64-bit] *[Wed Mar 28 17:12:33 2018] tg3 0000:03:00.2 eno3: renamed from eth0* [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.3 eth0: Tigon3 [partno(629133-001) rev 5719001] (PCI Express) MAC address d8:9d:67:2c:ec:e3 [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.3 eth0: attached PHY is 5719C (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[1]) [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.3 eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1] [Wed Mar 28 17:12:33 2018] tg3 0000:03:00.3 eth0: dma_rwctrl[00000001] dma_mask[64-bit] *[Wed Mar 28 17:12:33 2018] tg3 0000:03:00.3 eno4: renamed from eth0* I should note that this server is now in production, so it would be fantastic if I can solve this without taking down eno1 as that is the primary network link. Any help is greatly appreciated. Thanks! -- Dave Parker '11 Database & Systems Administrator Utica College Integrated Information Technology Services (315) 792-3229 Registered Linux User #408177
