On Sun, Nov 30, 2003 at 07:52:01AM -0500, Paul Morgan wrote
> Create a file in /etc/modutils containing the following:
>
> options ide-cd ignore=\"hdc hdd\"
> alias scd0 sr_mod
> alias scd1 sr_mod
> pre-install sg modprobe ide-scsi
> pre-install sr_mod modprobe ide-scsi
I think I may have screwewd up somewhere on the setup. Here are a few
excerpts from /var/log/dmesg
ide-floppy driver 0.97.sv
modprobe: modprobe: Can't locate module ide-cd
hdc: driver not present
/dev/hdc: No such device or address
ide-floppy driver 0.97.sv
modprobe: modprobe: Can't locate module ide-cd
hdd: driver not present
/dev/hdd: No such device or address
I'm not a kernel hacker, but I can "./configure && make && make install"
What is the procedure to set up ide-cd and make it available ? Here are
some more excerpts from dmesg...
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Kernel command line: auto BOOT_IMAGE=Linux ro root=301 hdc=ide-scsi hdd=ide-scsi
ide_setup: hdc=ide-scsi
ide_setup: hdd=ide-scsi
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x1420-0x1427, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0x1428-0x142f, BIOS settings: hdc:DMA, hdd:DMA
hda: Maxtor 6E040L0, ATA DISK drive
hdc: HITACHI DVD-ROM GD-5000, ATAPI CD/DVD-ROM drive
hdd: CD-RW CRX100E, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 80293248 sectors (41110 MB) w/2048KiB Cache, CHS=4998/255/63
ide-floppy driver 0.97.sv
Partition check:
hda: hda1 hda2 < hda5 hda6 hda7 >
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
SCSI subsystem driver Revision: 1.00
Red Hat/Adaptec aacraid driver, Aug 13 2003
DC390: 0 adapters found
3ware Storage Controller device driver for Linux v1.02.00.016.
3w-xxxx: No cards with valid units found.
request_module[scsi_hostadapter]: Root fs not mounted
request_module[scsi_hostadapter]: Root fs not mounted
i2o_scsi.c: Version 0.0.1
chain_pool: 0 bytes @ c1206f00
(512 byte buffers X 4 can_queue X 0 i2o controllers)
--
Walter Dnes <[EMAIL PROTECTED]>
Email users are divided into two classes;
1) Those who have effective spam-blocking
2) Those who wish they did
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
