On Tue, November 25 at 11:10 PM EST Simon Tod <[EMAIL PROTECTED]> wrote:
>I'm having no luck in getting a USB Mouse to work... > >/etc/fstab reports: > >none /proc/bus/usb usbfs defaults 0 0 > >On boot up into a Knoppix 2.4.20-xfs kernel I always >get... > >usb.c: registered new driver usbdevfs >usb.c: registered new driver hub >usb-uhci.c: $Revision: 1.275 $ time 18:50:40 Nov 15 >2003 >usb-uhci.c: High bandwidth mode enabled >usb-uhci.c: USB UHCI at I/O 0xfce0, IRQ 9 >usb-uhci.c: Detected 2 ports >usb.c: new USB bus registered, assigned bus number 1 >hub.c: USB hub found >hub.c: 2 ports detected >usb-uhci.c: v1.275:USB Universal Host Controller >Interface driver > >with the mouse plugged in when I boot, I additionally >get... > >usb.c: new USB device 00:07.2-1, assigned address 2 >usb.c: USB device 2 (vend/prod 0x45e/0x39) is not >claimed by any active driver >usb.c: registered new driver hiddev >usb.c: registered new driver hid >usb-uhci.c: interrupt, status 3, frame # 231 >input0: USB HID v1.10 Mouse [ Microsoft Microsoft >5-Button Mouse with IntelliEye(TM)] on usb1:2.0 >hid-core.c: v1.81.1 Andreas Gal, Vojtech Pavlik ><[EMAIL PROTECTED]> >hid-core.c: USB HID support drivers > >lsmod reports the additional modules keybdev, hid, >mousedev and input in addition to usbcore and usb-uhci >that are always there. > >As far as I can tell the mouse is recognised (albeit a >Microsoft mouse borrowed from work...!?), so what more >do I need to do to get it working? > >Using my 2.4.22 kernel I get a complaint of failed >attempt to load keybdev, but then, I disabled that in >my kernel compilation. Why do I need keybdev for a >mouse anyway?! > >Thanks... > I was able to get mine working with the steps here: http://www.linux-usb.org/USB-guide/x194.html under HID mouse configuration. HTH, Shawn >===== >----------------------- >Simon Tod >[EMAIL PROTECTED] Shawn Lamson [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
