On Thu, Nov 20, 2003 at 12:33:58PM -0600, Alex Malinovich wrote: > On Thu, 2003-11-20 at 10:36, Micha Feigin wrote: > > I configured my logitec usb optical wheel mouse (a lot of words for the > > standard one ;-) to repeat to X using the raw protocol. The problem is > > that under X the mouse only works when scrolling down and not when > > scrolling up. > > When configured to use /dev/input/mice directly everything works fine, > > so it doesn't seem to be the mouse (it also works under M$) > > I do need the gpm piping though as my computer is a laptop and thus the > > mouse isn't always connected and otherwise I would have to restart X to > > use it. > > > > /etc/gpm.conf: > > > > device=/dev/input/mice > > responsiveness= > > repeat_type=raw > > type=autops2 > > append="" > > sample_rate= > > > > The X setup for this mouse: > > > > Section "InputDevice" > > Identifier "Generic Mouse" > > Driver "mouse" > > Option "SendCoreEvents" "true" > > Option "Device" "/dev/gpmdata" > > Option "Protocol" "ImPS/2" > > Option "Emulate3Buttons" "true" > > Option "ZAxisMapping" "4 5" > > EndSection > > Judging by the fact that you're using /dev/input/mice, I'm guessing > you're using a USB mouse? If that's the case, all you need to do is have
I actually stated that but yes, it usb. > the mouse already defined in your XF86Config-4 (which it looks like you > already do) and just make sure your USB modules are loaded when you > start up X. Plugging in the mouse at any point after that should make it > "just work". I've been doing just this for a while with my laptop with > no problems. I thing that that is a problem since last time I checked, they didn't suspend properly (I am using swsusp to suspend my laptop instead of turning it off) so I need to unload the usb modules for suspend.(will check again just in case). Thanx > > -- > Alex Malinovich > Support Free Software, delete your Windows partition TODAY! > Encrypted mail preferred. You can get my public key from any of the > pgp.net keyservers. Key ID: A6D24837 > > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
