Hey all, I am trying to set up a basic print server, using an ancient PC. PC is 100Mhz Pentium, 16 Meg memory and 1 Gig disk drive. Way old stuff. So I did a Debian Woody install, no X, no desktop, - the only option I selected was Print Server. The install went okay, but I am having trouble bringing the Ethernet card up.
The card is an ISA bus card, I believe it is a Linksys Ether16 Combo (the person that donated it to the church I setting this up for stated it was a Linksys card). I did a "modprobe ne io=0x240 irq=10" and the card inserted properly. I tried a dozen or so combinations before that to get to the right io/irq combination. The link card comes on on the card. It also comes on on my hub. But when I do a "ifconfig eth0" I don't see any received packets, and only see errored transmit packets. The IP is 192.168.1.25/255.255.255.0 with a 192.168.1.1 gateway. DNS servers are configured. Eth0 is up. From the console I can ping my loopback address of 127.0.0.1. I can also ping my own IP address of 192.168.1.25. I can not ping the gateway. I can not ping any other PC's on the same hub. Other PCs on the network can not ping 192.168.1.25. The card is a combo card with a BNC connector and an 10BaseT connector. I can plug into the 10BaseT port and the light goes green - so am I safe in assuming the card is configured to use the RJ45 connector versus the BNC connector? Anyone familiar with this card and know how to check? Regards, Bruce -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
