Thanks for the reply. I rebooted, and as expected, grub threw up an error - "error: symbol not found: 'grub_divmod64_full' "
Had a bit of free time, and wiped the installation clean and installed Squeeze on it. Changed the repositories over to "testing", then updated everything to Wheezy again. Same segfault and error as previously. Any ideas? On Tue, Jun 21, 2011 at 7:34 PM, Camaleón <noela...@gmail.com> wrote: > On Mon, 20 Jun 2011 20:43:30 +0800, titantoppler wrote: > > > Did an upgrade on my computer running Wheezy today. grub-pc was one of > > the packages that needed to be updated. However, it failed with a > > segfault during the configuration. > > > > Syslog has this to say: > > Jun 20 20:34:59 argon kernel: [ 8265.445561] grub-probe[31617]: segfault > > at 14 ip 08077f0a sp bfd40b00 error 4 in grub-probe[8048000+3d000] > > > > Tried to uninstall and reinstall grub2 + grub-pc (stupid, now I don't > > dare to reboot the computer), but no dice - grub2 refuses to configure > > because of grub-pc, grub-pc still segfaults. > > (...) > > Any side effects? Is the computer bootable? If you can't boot from your > own GRUB, you could use any livecd rescue disk and boot from there unless > it's a remote system. > > If the segfault it's still reproducible, I would report it. > > Greetings, > > -- > Camaleón > > > -- > To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org > with a subject of "unsubscribe". Trouble? Contact > listmas...@lists.debian.org > Archive: http://lists.debian.org/pan.2011.06.21.11.34...@gmail.com > >
