Hi,
On Thu, 21 Aug 2003 12:36:35 -0300
jleclair <[EMAIL PROTECTED]> wrote:
|
|I'm trying to set up an old 486 as router/nat/firewall server for home network. The 2
nics are dlink 220 isa.
|When I run modconf, I choose the NE net module with this parameter:
| io=0x300
|This works and the module loads for eth0. How do I load the module now for the second
nic?
|I dont know the io address of the 2nd nic and the module will only load once. I guess
I could do something like: io=0x240,0x300 when loading the module through modconf.
|BTW, I guessed at the io address that DID respond and have since unloaded the module
and tried every other io address to make the second nic work. Are there tools to probe
for hardware responding on io addresses not listed
|in /etc/proc?
|I know this is all quite vague, but I am completely PCI plug-n-play spoiled.
|Thanks for any assistance!
|James
If they are isa then (informatical) you need 'isapnptools' and to
do a isapnp dump.
Then a config of /etc/isapnp.conf is needed. There you chose the irq and the io(s)
of your cards. (uncomment these lines)
The isapnptools must be started at boot of course.
The rest is a config of your cards as eth0 and eth1.
mess-mate
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
