-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 In a new box I decided to install Etch with a RAID array. In that box I had two 1 TB hard drives to use for a RAID 1 array. I discovered that there is much to installing a RAID array which is not explained in the Installation Guide.
The installer does not allow / (root), /boot or swap to be part of a RAID array. I consequently had to put them in only one of these hard drives as "ordinary" partitions, along with /tmp. The only partitions which are set up as RAID arrays are /usr, /var and /home. At least that what I think is the case, as the df command only shows "ordinary" partitions. Now, I assume that the purpose of RAID is to guard against loss of data if one of the drives in the array dies. In that case the data on the good drive will serve until the dead drive is replaced. If however the dead drive contains any of the / (root), /boot or swap partitions, the box would be unusable; as access to the good drive would be impossible. In such a situation I would not want to contemplate the hoops I would have to jump through to salvage the data from the good drive. The only way I can think of to avoid such a situation in this particular box where there are only two drives in the RAID array, it to have a third drive with everything but the /home partition stored in it, and use the RAID array only for /home. If so, I wonder why I should bother with RAID, as all data in the /home partition-directory needs to be backed up periodically in any event. Regards, Ken Heard -----BEGIN PGP SIGNATURE----- Version: GnuPG v2.0.9 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org iEYEARECAAYFAkkUvTMACgkQlNlJzOkJmTeRmgCdF+8A8ixAZHaE5IcxPAfArMTT CIUAn1nPI0NlFV6apwdFrPGV4hjJ02XM =DhZJ -----END PGP SIGNATURE----- -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
