Hi everyone, Here is the output I get when plugging the Z-Star webcam on debian etch (after installing gspca)
[ 193.752919] usb 2-1: new full speed USB device using uhci_hcd and address 2 [ 193.946032] usb 2-1: configuration #1 chosen from 1 choice [ 193.950260] usb 2-1: New USB device found, idVendor=0ac8, idProduct=301b [ 193.950276] usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=0 [ 193.950281] usb 2-1: Product: PC Camera [ 193.950285] usb 2-1: Manufacturer: Vimicro Corp. [ 195.115889] zc0301: V4L2 driver for ZC0301[P] Image Processor and Control Chip v1:1.10 [ 195.115959] usb 2-1: ZC0301[P] Image Processor and Control Chip detected (vid/pid 0x0AC8:0x301B) [ 195.195898] usb 2-1: No supported image sensor detected [ 195.195992] usbcore: registered new interface driver zc0301 [ 195.269743] gspca: main v2.1.2 registered [ 195.629504] usbcore: registered new interface driver zc3xx [ 195.849412] gspca: disagrees about version of symbol video_devdata [ 195.849433] gspca: Unknown symbol video_devdata [ 195.850119] gspca: disagrees about version of symbol video_unregister_device [ 195.850124] gspca: Unknown symbol video_unregister_device [ 195.850350] gspca: disagrees about version of symbol video_device_alloc [ 195.850354] gspca: Unknown symbol video_device_alloc [ 195.850441] gspca: disagrees about version of symbol video_register_device [ 195.850445] gspca: Unknown symbol video_register_device [ 195.850942] gspca: disagrees about version of symbol video_device_release [ 195.850946] gspca: Unknown symbol video_device_release What would be the cause? BTW, I am working on a 2.6.25 kernel from backports. Regards -- If the only tool you have is a hammer, you will see every problem as a nail
