I am trying to burn iso image to DVD with no success. Already wasted 5 discs and have no clue what is wrong.
Here is what dmesg report after wodim filed to write to DVD: $ dmesg | tail attempt to access beyond end of device hdc: rw=0, want=68, limit=4 isofs_fill_super: bread failed, dev=hdc, iso_blknum=16, block=16 butt I think that iso image is not bigger than it should be: $ ls -l w.iso -rw-r--r-- 1 misko misko 4344049664 2008-01-21 18:29 w.iso What confuse me Why is Total size reported by wodim so much bigger than real image size? Track 01: data 4142 MB Total size: 4757 MB (471:21.57) = 2121118 sectors Lout start: 4758 MB (471:23/43) = 2121118 sectors Here is full output from wodim: $ wodim -v -sao speed=1 w.iso Quickly guessing the name of a drive capable to write DVD-R, please wait... Found /dev/dvdrw, assuming dev=/dev/dvdrw TOC Type: 1 = CD-ROM scsidev: '/dev/dvdrw' devname: '/dev/dvdrw' scsibus: -2 target: -2 lun: -2 Linux sg driver version: 3.5.27 Wodim version: 1.1.2 Driveropts: 'burnfree' SCSI buffer size: 64512 atapi: 1 Device type : Removable CD-ROM Version : 0 Response Format: 2 Capabilities : Vendor_info : 'HL-DT-ST' Identification : 'DVDRAM GSA-H10N ' Revision : 'JL10' Device seems to be: Generic mmc2 DVD-R/DVD-RW. Current: 0x001B (DVD+R) Profile: 0x0012 (DVD-RAM) Profile: 0x0011 (DVD-R sequential recording) Profile: 0x0015 (DVD-R/DL sequential recording) Profile: 0x0016 (DVD-R/DL layer jump recording) Profile: 0x0014 (DVD-RW sequential recording) Profile: 0x0013 (DVD-RW restricted overwrite) Profile: 0x001A (DVD+RW) Profile: 0x001B (DVD+R) (current) Profile: 0x002B (DVD+R/DL) Profile: 0x0010 (DVD-ROM) Profile: 0x0009 (CD-R) Profile: 0x000A (CD-RW) Profile: 0x0008 (CD-ROM) Profile: 0x0002 (Removable disk) Using generic SCSI-3/mmc DVD-R(W) driver (mmc_mdvd). Driver flags : SWABAUDIO BURNFREE Supported modes: PACKET SAO Drive buf size : 1114112 = 1088 KB Beginning DMA speed test. Set CDR_NODMATEST environment variable if device communication breaks or freezes immediately after that. Drive DMA Speed: 13873 kB/s 78x CD 10x DVD FIFO size : 4194304 = 4096 KB Track 01: data 4142 MB Total size: 4757 MB (471:21.57) = 2121118 sectors Lout start: 4758 MB (471:23/43) = 2121118 sectors Current Secsize: 2048 ATIP start of lead in: -150 (00:00/00) ATIP start of lead out: 157789 (35:05/64) Disk type: unknown dye (reserved id code) Manuf. index: -1 Manufacturer: unknown (not in table) Blocks total: 2295104 Blocks current: 2295104 Blocks remaining: 173986 Speed set to 5540 KB/s Starting to write CD/DVD at speed 4.0 in real SAO mode for single session. Last chance to quit, starting real write 0 seconds. Operation starts. Waiting for reader process to fill input buffer ... input buffer ready. Performing OPC... Sending CUE sheet... Starting new track at sector: 0 Track 01: 4142 of 4142 MB written (fifo 100%) [buf 98%] 4.2x. Track 01: Total bytes read/written: 4344049664/4344049664 (2121118 sectors). Writing time: 796.939s Average write speed 4.0x. Min drive buffer fill was 44% Fixating... Errno: 0 (Success), close track/session scsi sendcmd: no error CDB: 5B 00 02 00 00 00 00 00 00 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 02 00 00 00 00 10 00 00 00 0E 04 08 00 80 Sense Key: 0x2 Not Ready, Segment 0 Sense Code: 0x04 Qual 0x08 (logical unit not ready, long write in progress) Fru 0x0 Sense flags: Blk 0 (not valid) operation 0% done cmd finished after 0.002s timeout 1000s Fixating time: 0.196s -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
