Hi,
I have a server running cups, with a wireless usb connector connected to
a remote Brother 5040 laser printer. It's always worked fine, modulo a
little crackle on the television when printing ;-)
After upgrading the server to etch (without any major problems) cups no
longer sees the printer. Cups is running ok, and knows about the
printer, but the web interface always displays the message:
" HL5040 (Default Printer) "Printer not connected; will retry in 30
seconds..."
lsusb shows that the printer is there, and visible over wireless:
snoopy: lsusb
Bus 003 Device 002: ID 13fd:0540
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 028: ID 04f9:0016 Brother Industries, Ltd
Bus 001 Device 001: ID 0000:0000
lsmod shows I have the usb modules:
snoopy: lsmod
<snip>
ehci_hcd 27144 0
ohci_hcd 17540 0
sis900 21120 0
mii 5376 1 sis900
usbcore 109444 5 usblp,usb_storage,ehci_hcd,ohci_hcd
I guess this is yet another strangeness with changes to udev? Has anyone
else run into the same problem, or found a solution?
Thanks
Graham
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
