On bootup - Etch, stock 2.6.18 kernel - my Brothers HL-730 laser printer
prints a partial test page and stops with the error light flashing.
I don't need or want this test page. The printer is almost 10 years old
but it works fine on those rare occasions (like income tax preparation)
when I must sin (aka boot to windows).
It always worked fine with CUPS too and probably would still if it were
not locked up on an error.
I haven't been able to track down the reason this test page prints. I
have looked at some of the rc2.d files at .gconf (the test print starts
just as gdm is loading) without success.
Any hints as to where to look next?
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
