hi ya jesse

On Tue, 15 Jul 2003, Jesse Meyer wrote:

> On Tue, 15 Jul 2003, Alvin Oga wrote:
> > > > I am trying to install a 120 GB hard drive as a third hard drive on a
> > > > Pentium 75 with a cmd640 IDE interface.  I am attempting to replace a
> > > > 60GB hard drive that has been working without any problems.  When I
> > > > install the 120GB hard drive Linux only sees it as a 132 MB hard drive. 
> > > > Does anyone know what I can do to fix this?  Below is the boot up
> > > > messages with the 60GB hard drive as the third drive (hdc) and the 120
> > > > GB hard drive as the fourth drive (hdd).
> > 
> > the cable nor controller should affect "capacity" it sees
> > 
> > root# fdisk -l /dev/hdc
> > -- should tell you how many cylnder/sector/heads it thinks there is
> > 
> > i suspect your p5 mb is too too old
> >     - check that the bio supports ata-66/ata-100/ata-133
> >     ( probably doesnt )
> > 
> >     - check that the jumpers on the drive is setup for "big disk"
> >     ( jumper setting varies w/ manufacturer (ibm, maxtor, wd, seagate)
> > 
> >     - check the kernel supports the ide chipset on the mb
> 
> bzzt!  Misleading, if not wrong.

guess i didn't write clearly enuff ... aint da 1st time :-)
 
> After linux boots, it does not use the bios to deal with any other 
> disks. 

see the line "fdisk -l /dev/hdc" ... that's the equivalent of your comment

>  For example, I have an old p166 which has a 80 gig HDD as the 
> secondary master drive.  Although the bios doesn't see it, linux uses it
> without a problem, and has been for over a year now.  (Linux even
> enables SMART on it, which the bios does not understand).
> 
> So, while you might have a few problems booting from a 120 GB HDD, you 
> should have no problems accessing a 120 GB HDD once booted.

i think the problem is he wants to boot off the 120GB disk ...
and the system wont boot until it knows what to do with 120GB disk
        - if the bios doesn't know what to do... it wont boot
        and since it sees it as 130MB, its an old bios that wont
        work

        - if you have an initrd .. you can make it work and boot off
        the 120GB disk

once linux is up and running, double check your disk capacities

c ya
alvin


-- 
To UNSUBSCRIBE, email to [EMAIL PROTECTED] 
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]

Reply via email to