Hi,
I am not sure where to report this bug, if it's a bug at all, and so I am posting it here
I am using debian 'testing' fully updated.
When I try to use Totem to play a dvd, the DMA mode of my dvd player gets disabled:
hda: irq timeout: status=0xd0 { Busy }
ide: failed opcode was: unknown
hda: DMA disabled
hda: ATAPI reset complete
And as a result the playback is bad, it stops and than starts again a couple of times in
a second.
I started Totem in the console and this is the output:
~$ totem
closing
closing
closing
closing
libdvdnav: Using dvdnav version 1.1.1 from http://xine.sf.net
[...]
When the messages "closing" start to appear, I hear my drive trying to do something
with the door, I assume it's trying to close itself, but it's already closed.
Here's the output of hdparm (before I try playing with totem):
hdparm -vi /dev/dvd
/dev/dvd:
IO_support = 0 (default 16-bit)
unmaskirq = 0 (off)
using_dma = 1 (on)
keepsettings = 1 (on)
readonly = 0 (off)
readahead = 256 (on)
HDIO_GETGEO failed: Inappropriate ioctl for device
Model=_NEC DVD_RW ND-3540A, FwRev=1.01, SerialNo=
Config={ Removeable DTR<=5Mbs DTR>10Mbs nonMagnetic }
RawCHS=0/0/0, TrkSize=0, SectSize=0, ECCbytes=0
BuffType=unknown, BuffSize=0kB, MaxMultSect=0
(maybe): CurCHS=0/0/0, CurSects=0, LBA=yes, LBAsects=0
IORDY=yes, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 *udma2
AdvancedPM=no
* signifies the current active mode
When playing with "codeine" player, there are no problems whatsoever, it does not
disable the dma mode of my drive.
Please, advise me what to do.
Thank you!
Steve
- Totem tries to close already closed drive, disables dma Steven
