Hello There, I am trying to print a .pdf file to an HP Designjet 750C roll feed plotter.The length of the plot is equal to 3.5 x A0 sheets but I cannot get it to print the whole thing as I wish, it only does a single A0 sheet taken from the middle of the plot window. I have set the plotter to 'Inked Area' as this looks as though it should then set the plot size accordingly. On the PC, when I go into print set-up I can select 'custom size' but then when going into the Printer wizard/set-up window on the PC I am not able to select anything other than standard sheet sizes! why is this? Would a latest version of the printer driver allow this command or does it need some special code tweaking?
A quick response would be very much appreciated Best regards Ken Clark Chief Mechanical Engineer Thales Underwater Systems Ocean House Templecombe Somerset BA8 0DH Tel 01963 372515 Fax 01963 372747 email [EMAIL PROTECTED] Many Thanks Ken This email, including any attachment, is a confidential communication intended solely for the use of the individual or entity to whom it is addressed. It contains information which is private and may be proprietary or covered by legal professional privilege. If you have received this email in error, please notify either the sender or telephone ++ 44 (0) 1963 370551 upon receipt, and immediately delete it from your system. Anything contained in this email that is not connected with the businesses of Thales Naval is neither endorsed by nor is the liability of this company. Whilst we have taken reasonable precautions to ensure that any attachment to this email has been swept for viruses, we cannot accept liability for any damage sustained as a result of software viruses, and would advise that you carry out your own virus checks before opening any attachment. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
