On Sun, 28 May 2006, Edson Marco Ferrari Junior wrote: > Hi all! > > Im try connect a webcam Genius in Debian Sarge. > > I install the module spca52xxx and quickcam, but when connect the > webcam in USB (2.0) in dmesg returns this message: > > usb 2-2: new full speed USB device using uhci_hcd and address 6 > usb 2-2: device not accepting address 6, error -71 [ ... ]
I had similar problems with my Creative WebCam NX Pro 2. After much googling I found the following suggestion worked. Try plugging the camera into a USB _1.x_ hub (or try bypassing the hub completely). Either workaround solved the problem for me. My camera won't initialize correctly if it's plugged into any of my USB 2 hubs (or into an add-on NEC-chipset USB2 pci card for that matter). It seems this is a semi-common issue with webcams (not just the spca52xxx driver). I don't know why USB transactions with a webcam would be so touchy, but a USB hard drive runs fine a full capacity through the same USB port... -- Brad -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
