Peter,
thanks, I actually did use that guide to do the set-up, and it was
very helpful. the problem I have is how do I move from having either
a RAID0 or RAID1 to having BOTH.
I have the four disks broken up into two RAID0 arrays of two disks
each. what I want to do now is have the two RAID0 disks be
'mirrored' to each other - i.e. RAID1
when I try to use the "Create MD" It am told that I don't have any
RAID partitions; but I can't set the RAID) partitions to physical
RAID partition either.
so that's where I am stalled out. I have the two RAID0 but can't
figure out how to create a RAID1 out of them.
-M
On Feb 20, 2006, at 1:52 PM, Peter Colton wrote:
On Monday 20 February 2006 16:47, Morgan Reed wrote:
Fresh install of Debian 3.1 on a box with 4 SCSI 18.2 GB HD. SCSI
card is a non-RAID adaptec card.
I am trying to set up the 4 drives as 2 RAID0 of 36 Gig each mirrored
(RAID1)
Morgan
Hello Morgan,
Have a look at the link below its should be of help setting up a
software
raid1. If you are using lvm as well at the beging of the expert
install, pick
the mdcfg module and the lvmcfg module.
" Installing Debian Sarge with software RAID "
http://nepotismia.com/debian/raidinstall/
Regards
peter colton
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact
[EMAIL PROTECTED]
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
