Sorry, I was out of town last week. Responses below. Rick <[EMAIL PROTECTED]> writes:
> Should the FA311 card be listed in early part of the kernel > messages? I see the message about the card pretty soon after the SCSI disks are identified. Here is the relevant section from my kern.log: Jun 7 19:48:36 localhost kernel: natsemi.c:v1.07 1/9/2001 Written by Donald Becker <[EMAIL PROTECTED] yld.com> Jun 7 19:48:36 localhost kernel: http://www.scyld.com/network/natsemi.html Jun 7 19:48:36 localhost kernel: The PCI BIOS has not enabled the device at 0/128! Updating PCI command 0203->0207. Jun 7 19:48:36 localhost kernel: eth1: NatSemi DP83815 at 0xcc85a000, 00:02:e3:14:d4:5b, IRQ 1 7. Jun 7 19:48:36 localhost kernel: eth1: Transceiver status 0x7869 advertising 0000. I am sorry to say that I don't know what the last several lines mean. > Brian, is pci-scan.o on your system? It was not on mine, and I had > to compile it from the sources. Neither pci-scan nor natsemi were on my system. I got the source RPM from somewhere (probably www.scyld.com) and unpacked it in /usr/src/RPM. I built everything and copied pci-scan.o and natsemi.o into /lib/modules. Then I made links to those two files in the appropriate directories: [EMAIL PROTECTED]:$ ls -l /lib/modules/2.2.19/net/ total 4 -rw-r--r-- 1 root root 2452 Dec 6 2001 dummy.o lrwxrwxrwx 1 root root 22 Dec 6 2001 natsemi.o -> /lib/modules/natsemi.o lrwxrwxrwx 1 root root 23 Dec 6 2001 pci-scan.o -> /lib/modules/pci-scan.o > Also Brian, where did you find out about ifup and > /etc/network/interfaces? None of the Linux networking references I > have even mention it. I am not completely sure, but I probably saw some reference to the interfaces file on some debian list. man interfaces has a thorough description of the contents of the file, and I recall reading it. > The output of lspci is: > > 00:14.0 Ethernet controller: National Semiconductor Corporation > DP83815 (MacPhyter) Ethernet Controller Mine is identical. > modprobe -v natsemi results in no response. Neither do I. > Excerpts from dmesg: > natsemi.c:v1.07 1/9/2001 Written by Donald Becker <[EMAIL PROTECTED]> > http://www.scyld.com/network/natsemi.html > (unofficial 2.4.x kernel port, version 1.07+LK1.0.14, Nov 27, 2001 > Jeff Garzik, Tjeerd Mulder) > eth0: NatSemi DP8381[56] at 0xc482a000, 00:40:f4:52:0f:24, IRQ 9. > eth0: Transceiver status 0x7849 advertising 0x5e1. > eth0: autonegotiation did not complete in 4000 usec. Could this be a kernel issue? I am running 2.2, not 2.4? Brian -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
