On Wed, Jan 11, 2006 at 09:41:21AM -0600, Ron Johnson wrote: > On Tue, 2006-01-10 at 23:22 +0000, Steven Flintham wrote: > > SCSI device sdc: 2031616 1024-byte hdwr sectors (2080 MB) > > sdc: Write Protect is off > > /dev/scsi/host2/bus0/target0/lun2:<6>usb.c: USB disconnect on device > > 00:07.2-2address 2 > > hub.c: new USB device 00:07.2-2, assigned address 3 > > WARNING: USB Mass Storage data integrity not assured > > USB Mass Storage device found at 3
> The maximum size of a FAT16 FS is 2GB. Maybe there's an "off by 1" > error? > > Have you tried formatting it FAT32, or re-partitioning sdc1 1.95GB? Thanks, and also to the other poster who suggested this. Unfortunately I don't seem to be able to repartition, when do I: # fdisk /dev/sdc it seems to hang and dmesg shows the following: SCSI device sdc: 2031616 1024-byte hdwr sectors (2080 MB) sdc: Write Protect is off /dev/scsi/host2/bus0/target0/lun2:<6>usb.c: USB disconnect on device 00:07.2-2address 2 hub.c: new USB device 00:07.2-2, assigned address 3 WARNING: USB Mass Storage data integrity not assured USB Mass Storage device found at 3 scsi: device set offline - not ready or command retry failed after bus reset: host 2 channel 0 id 0 lun 2 I/O error: dev 08:20, sector 0 I/O error: dev 08:20, sector 0 unable to read partition table Similar problems occur if I try to make a filesystem using something other than mkdosfs. Am I doing something obviously wrong? It could be the card reader is fundamentally incompatible with the card for some reason, I may see if I can arrange to try it on a Windows box as a diagnostic measure. Thanks. Steve -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
