Using wlan0 solved this:
Paul Scott wrote:
After updating relevant packages (pcmciautils?) on my sid system with
latest 2.6.14-2 kernel my 16-bit DLink Air DWL- 650 no longer gets
configured.
My existing /etc/network/interfaces is still trying to configure eth0
which worked until this last upgrade. I have had ifplugd installed
for a while and this was working.
ifconfig gives these new entries ( I omitted the irrelevant entries):
wifi0 Link encap:UNSPEC HWaddr
00-40-05-DE-D2-07-30-3A-00-00-00-00-00-00-00-00 UP BROADCAST
RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:5 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:468 (468.0 b)
Interrupt:5 Base address:0x100
wlan0 Link encap:Ethernet HWaddr 00:40:05:DE:D2:07 inet6
addr: fe80::240:5ff:fede:d207/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:5 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:468 (468.0 b)
Interrupt:5 Base address:0x100
I am also studying how to use udev rules to solve this if necessary.
TIA for any ideas,
Paul Scott
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
