New sarge install. System is on hda under lvm, works fine. Created raid 5 device after system was built dmesg shows autodetect of the array
Array doesn't start (nor lvm on top of it) during boot though. I've kludged it by adding a S49mdadm and S50lvm script to rc2.d but this is after fstab has been read, so I can't put any mounts in it and would have to write another script to mount all these (which are nfs and samba exports, nothing to the local system) It all seems rather kludgy to me ... what do I have to do to get the array and lvm to start during the normal boot sequence early enough such that mount points can be in fstab? Again ... it sees the array: md: md0 stopped. md: bind<sdb1> md: bind<sdc1> md: bind<sda1> raid5: automatically using best checksumming function: pIII_sse pIII_sse : 5448.000 MB/sec raid5: using function: pIII_sse (5448.000 MB/sec) md: raid5 personality registered as nr 4 raid5: device sda1 operational as raid disk 0 raid5: device sdc1 operational as raid disk 2 raid5: device sdb1 operational as raid disk 1 raid5: allocated 3160kB for md0 raid5: raid level 5 set md0 active with 3 out of 3 devices, algorithm 2 RAID5 conf printout: --- rd:3 wd:3 fd:0 disk 0, o:1, dev:sda1 disk 1, o:1, dev:sdb1 disk 2, o:1, dev:sdc1 AND the base system is running under LVM ... TIA for any advice ... -- Hank Marquardt <[EMAIL PROTECTED]> GPG Id: 2BB5E60C Fingerprint: D807 61BC FD18 370A AC1D 3EDF 2BF9 8A2D 2BB5 E60C -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
